IEMCA SIR52 MS52 F, Manual For Use And Maintenance

Page: 49 / 212

4 - HANDLING AND INSTALLATION SIR 52 MS52 P/F
EN
4 - Pag. 21 / 22
4.7 PNEUMATIC CONNECTION
- Connect pipe (D) of the pneumatic system to
the quick coupling (G).
FILTER A
• Make sure that cup (B) is not full of
condensate. If need be, bleed the condensate
by valve (C).Make sure that cup (B) is not full
of condensate. If need be, bleed the
condensate by valve (C).
PRESSURE SWITCH
• The lubrication system is equipped with a
control pressure switch, set to a pressure of
4.5 bar.
• Proceed as follows to adjust the pressure
switch:
- remove the pressure gauge protecting
glass;
- turn the adjusting screw (G) anticlockwise
(+) to increase pressure or clockwise (-) to
lower it;
- after this operation, replace the pressure gauge protecting glass.
CAUTION:
should the pressure switch needle point a Pressure=0, do not absolutely turn
the adjusting screw (H) clockwise (-), for this will cause pressure switch
breakage.
4.8 ALIGNMENT - FINAL CHECK
When the installation is over, make sure clamp
device (A) axis is aligned with the guide channel
axis.
Keep to the following procedure: move the clamp
device to the "bar insertion into collet" position and
close the sprockets by pressing key
. Sprockets
must close without interfering with the bar pusher
inserted into the clamp device.
In case of misalignment, please apply to IEMCA
technical assistance department.