IEMCA SIR52 MS52 F, Manual For Use And Maintenance

Page: 41 / 212

4 - HANDLING AND INSTALLATION SIR 52 MS52 P/F
EN
4 - Pag. 13 / 22
- For the rear cross adjustments, land two
calibrated blows in the feet plates side with a
mallet.
For the front cross adjustments and the front
adjustments in height, act on screws (L) and
(B).
During this phase, the adjustments done while
levelling must be respected; in most cases, it is
therefore necessary to find the right adjustment
of the bar feeder position.
- With a vernier caliper, check the cross alignment
of those positions pointed out by the arrows;
adopt a ± 0.15 mm tolerance.
To check the height and the front centering,
introduce centering pins in the rear driving plate
moving the feeding drum forwards and
backwards.