IEMCA SIR52 MS52 F, Manual For Use And Maintenance

Page: 82 / 212

EN
6 - USE AND OPERATION SIR 52 MS52 P/F
6 - Pag. 10 / 30
Reset the drilling machine following these instructions:
1) The motor must be in wait position, otherwise press the RESET button to move it to wait
position.
2) Keep pressing button F25 for 5 seconds: all the devices on the drilling machine will be
released.
3)If a bar is clamped in the vice, the feeding unit will not open and the levers will not come
down.
4) The motors will stop.
5) Press button F30 to move the bar backward after the motor has been driven backward and
the bar sensing photocell has been released.
6)Press button F25 again to open the rollers and to bring the lever down to rest position.
S38 Button Drilling machine stop/Spindle return
- Press this button to stop drilling machine operation (alarm nr. 60 " Drilling machine cover"
will be displayed). Keep pressing the button to let the spindle return to the rest position.
- This position allows spindle or tool maintenance. After maintenance has been completed,
press button S32 to reset alarm nr. 60 and restore drilling machine to normal operation.
- If button S32 is pressed as soon as alarm nr. 60 " Drilling machine cover" is displayed the
drilling machine is restored immediately to normal operation.
Press this button to stop drilling machine operation without stopping either bar feeder or lathe
working cycles.
Press button S38 and then button F25 to restore the position of the devices of the drilling
machine and restore operation.