IEMCA SIR52 MS52 F, Manual For Use And Maintenance

Page: 58 / 212

EN
5 - ADJUSTMENTS AND SETTING-UP SIR 52 MS52 P/F
5 - Pag. 8 / 22
OPERATIONS REQUIRED TO SET UP
"STAGGERED SPROCKETS WORKING MODE"
- Set parameter 18 "Guide working mode (0-1)" to
mode 1; see the "Keyboard Instruction Manual".
- Set the guide channel opening cylinder stroke as
follows:
• open rear guard (C);
• remove fork (D) and move nose (E) axially;
• insert the fork in the slot corresponding to the
required mode according to the scheme shown in
the table;
Guide channel
Configuration
*
Position
of
pin B
Slot
for
Fork D
Setting
for
staggered
channel
57 53 4 -- a
46 43 3 IV b
33 33 2 III c
19 19 1 II d
- Close the sprockets by pressing the button.
(*)The configuration of the guide channel must be carried out according to the bar feeder
tooling and to the lathe type.
INFORMATION:
If shaped bars (i.e. hexagonal or square bars) are loaded, revolving speed
should be reduced in order to prevent premature wear and tear of the sprockets.