63
Fig. 2
Fig. 1
Fig. 3
Fig. 4
A
REMOVING THE FUEL PUMP, CHECK / REPLACE PLASTIC DRIVE
The fuel pump is connected with the burner motor by a plastic drive. When we have some problems con-
nected to the plastic drive, remove the fuel pump from the burner motor and check and/or replace it.
Following you found the operations to do to remove the fuel pump and check that the plastic drive is
undamaged or otherwise replace it.
1. Fig. 1
shows how the fuel pump is connected with the burner motor inside a high pressure washer,
assembled with the heater.
2. Unscrew with an open-end wrench and remove ,the inlet fuel pipe from the fuel pump side (
fig. 2
).
3. Unscrew with an allen key (
fig. 3
) the three screws that join the fuel pump to the burner motor.
4. Remove the fuel pump (
fig. 4
), check the plastic drive (
A
) and, if is necessary, replace it.
9.8 HEATER
MAINTENANCE
Vertical heater models were created to meet even the most diverse needs in the field of professional pres-
sure washer.
In addition to ensuring compliance with operation, combustion and high efficiency standards, as is now
required by the market and regulations, they also offer features that are valued by the end customer,
including:
•
Low maintenance required.
•
Quick to reach operating temperature.
•
Low smoke production immediately following at start up and shutdown.
TECHNICAL DATA
Model
T 2000/2
Recommended flow rate
13-18 l/min
Fuel nozzle max
1.50 gl/h
Fuel consumption
5,70 kg/h
Heat capacity
58.000
Kcal/h
Max efficiency
90 %
Max pressure
220 bar
Weight
49 kg
Dimensions
(mm)
A
B
C
650
320
560
9 - MAINTENANCE
Cop
yrigh
t ©2016 I
dr
obase G
roup
. A
ll righ
ts r
eser
ved
.
