56
8 - USER INSTRUCTIONS
8.7
STOPPING AND PAUSING OPERATION
When you have finished the washing procedure stop the machine and store it according to the following
sections.
8.8
STOPPING OPERATION
1. When using a hot water machine, run the pressure washer with cold water for a few minutes by tur-
ning the thermostat to 0°C (zero °C).
2. Completely close the tap connected to the water supply.
3. Empty the pressure washer of any residual water by pressing the trigger of the gun for a few seconds.
4. Push the OFF button of the ON-OFF switch (
P
) of the machine.
5. Turn the master switch in OFF position.
6. Remove the plug from the wall socket.
7. Eliminate any remaining pressure in the high pressure hose by keeping pressed the trigger on the
gun for a few seconds.
8.9
EMERGENCy STOP
To carry out an emergency stop press the OFF button of the ON-OFF switch (
P
) placed on the control panel
(
L
) of the machine.
8.10
RESETTING CONDITIONS
To reset the initial conditions refer to the section 8.2 DESCRIPTION OF THE OPERATIONS TO BE CARRIED
OUT AND FUNCTIONING.
8.11
STORAGE OPERATION
8. Wait for the pressure washer to cool, taking care not to leave it unattended or near inflammable ma-
terials.
9. Carefully re-wind the power cable.
10. Remove the water hose from the tap.
11. Carefully re-wind the high pressure hose, while avoiding twisting or bending.
12. Store the pressure washer in a level, clean, dry place.
WARNING!
THE PRESSURE WASHER CANNOT WITHSTAND VERy COLD TEMPERATURES. DO NOT LEAVE THE
MACHINE IN AN ENVIRONMENT IN WHICH THE TEMPERATURE IS LESS THAN 5°C.
IN CASE OF STORAGE IN A COLD ENVIRONMENT, WITH A TEMPERATURE LOWER THAN 5°C, FIRST
FOLLOW THE PROCEDURE FOR STOPPING THE MACHINE, AND ONLy AFTER HAVING CONSULTED A
QUALIFIED TECHNICIAN IT IS POSSIBLE TO USE ANTIFREEZE IN THE PRESSURE WASHER.
UNSUITABLE LIQUID ANTIFREEZE CAN DAMAGE THE SEALS OF THE PUMP.
THE FAILURE TO RESPECT THESE SIMPLE PRECAUTIONS CAN CAUSE SERIOUS DAMAGE TO THE
PRESSURE WASHER.
Cop
yrigh
t ©2016 I
dr
obase G
roup
. A
ll righ
ts r
eser
ved
.