HDC-TH200 User Guide/Command Guide
52
8.5.11 [ F50 ] Vertical start position
You can set vertical display start position for analog video input.
Setting value
10 to 2048 : 10 lines to 2048 lines
Setting range is limited by total number of vertical lines, display period of vertical lines, and vertical sync signal
width.
Maximum setting value is “total number of vertical lines - display period of vertical lines -1”.
Minimum setting value is “vertical sync signal width +1”.
【
See: 8.5.12 [ F51 ] Display period of vertical lines
【
See: 8.5.13 [ F52 ] Vertical sync signal width
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
8.5.12 [ F51 ] Display period of vertical lines
You can set display period of vertical dots for analog video input.
Setting value
10 to 2048 : 10 lines to 2048 lines
Setting range is limited by total number of vertical lines and vertical display start position.
Maximum setting value is “total number of vertical lines – vertical display start position -1”.
【
See: 8.5.11 [ F50 ] Vertical start position
Notes:
・
When you change this setting by using “ + ” and “ - ” buttons the LED blinks. During the LED is blinking,
press
“SET” button and changes are executed.
If you do not operate more than 10 seconds during the LDE blinking, changes are not executed.
・
If there is no analog
signal, it shows “- - -” and cannot change settings.
