Power over Ethernet (PoE)
This must
ONLY
be installed with the supplied PoE injector (POE61W-560DG) and PoE splitter (POE45-120-R).
Mains Input
Entry Station
IN
OUT
Ethernet Switch
PoE Injector PoE Splitter
IN
OUT
Red: 12VDC
Black: 0V GND
White: Positive
Black: Negative
Ethernet Connection
⦁
Connect the
Ethernet Switch
to the
IN
port of the
PoE injector
.
⦁
Connect the
OUT
port of the
PoE injector
to the
IN
port of the
PoE splitter
.
⦁
Connect the
OUT
port of the
PoE splitter
to the RJ45 Ethernet connector on the back of the
entry station
.
9-PIN Expansion Power Connection
⦁
Connect the
white
(positive) wire from the PoE splitter to the
red
(12V DC) wire of the expansion cable.
⦁
Connect the
black
(negative) wire from the PoE splitter to the
black
(0V GND) wire of the expansion cable.
⦁
Connect the expansion cable to the 9-Pin expansion connector on the back of the
entry station
.
Output Connection
The entry station has one onboard programmable open collector output suitable for digital relay control. It should
be connected as indicated in the diagram below:
1K5 OHM
LED
+12V AUX
PRT-ENTR-17 | Protege Vandal Resistant Touchscreen Entry Station | Installation Manual
11
