![background image](http://html1.mh-extra.com/html/ics/linker-iia/linker-iia_user-manual_3528704055.webp)
54
FUNCTION:
ACTIVATE XPEAT
FUNCTION CODE:
105
PURPOSE:
Tells the controller to operate in the XPEAT mode
HOW TO USE:
1.
Keyup
2.
Enter the ACTIVATE XPEAT function code
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication.
5.
The controller will now operate in the XPEAT mode
The XPEAT mode will transmit on TX 2 when RX 1 is activated and on TX 1 when RX 2 is activated. Only one path
will operate at a time. RX 1 to TX 1 will have priority.
This status (controller in XPEAT mode will be the power up mode if the SAVE STATUSES function (#87) is used.
In the XPEAT mode the IDER will function on TX 1. Please note, the IDer will work in XPEAT in versions starting
with version 1.22 of the Linker IIa software.
To make this function permanent (Function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
FUNCTION:
SET PORT 2 TO HALF DUPLEX
FUNCTION CODE:
106
PURPOSE:
Tells the controller to allow either RX 2 or TX 2 to operate – not both
HOW TO USE
1.
Keyup
2.
Enter the SET PORT 2 TO HALF DUPLEX function code
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication.
5.
RX 2 and TX 2 will now not operate at the same time.
When Port 2 is in HALF DUPLEX it will active TX 1 and TX 2 when RX 1 becomes active but the controller will
only activate TX 1 if RX 2 becomes active.
To make this function permanent (Function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
This is the Default mode for Port 2.
Summary of Contents for Linker IIa
Page 12: ...11...