55
FUNCTION:
SET PORT 2 TO FULL DUPLEX
FUNCTION CODE:
107
PURPOSE:
Sets Port 2 to full duplex
HOW TO USE:
1.
Keyup
2.
Enter the SET PORT 2 TO FULL DUPLEX function code
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication.
5.
Port 2 will now operate in full duplex mode.
When Port 2 is in full duplex TX 1 and TX 2 will always be activated when either RX 1 or RX 2 is active.
To make this function permanent (Function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
FUNCTION:
SET PORT 2 TO SLAVE REPEATER
FUNCTION CODE:
108
PURPOSE:
Puts the controller into Slave Repeater Mode
HOW TO USE:
1.
Keyup
2.
Enter the SET PORT 2 TO SLAVE REPEATER function code
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication.
5.
The SET PORT 2 TO SLAVE REPEATER encode will now be enabled.
This function will put the controller into slave repeater mode. The slave repeater mode allows the operation of two
repeaters at one time. The repeaters will have the same audio and will ID at the same time.
To make this function permanent (Function stays active after power up or reset) the SAVE STATUSES function
(function # 87) must be used.
Summary of Contents for Linker IIa
Page 12: ...11...
