![background image](http://html1.mh-extra.com/html/ics/linker-iia/linker-iia_user-manual_3528704018.webp)
17
Definition of Terms used
1.
Key up – To activate the Control or Repeaters receiver COS (The repeaters receiver needs to be allowed to do
DTMF control)
2.
Unkey – To deactivate The Control or Repeaters receiver COS
3.
COMMAND ACCEPTED indication – The controller sends a CW letter “K” for “OK”
4.
ENTER NEXT DATA code – The controller sends a CW letter “M” for “ready for MORE information”
5.
TX 1 = Transmitter 1 (typically the repeaters transmitter)
6.
TX 2 = Transmitter 2 (typically the remote base / link transmitter)
7.
RX 1 = Receiver 1 (typically the repeaters receiver)
8.
RX 2 = Receiver 2 (typically the remote base / link receiver)
9.
FUNCTION = “command / function” as described in the previous text
10.
A decimal point can be entered on some functions by using the ‘*’ key on your touch pad
FUNCTION:
ENABLE TX 1
FUNCTION CODE:
32
PURPOSE:
Enables the TX 1 output
HOW TO USE:
1.
Key up
2.
Enter the ENABLE TX 1 function code.
3.
Unkey
4.
The controller sends the COMMAND ACCEPTED indication
5.
The TX 1 output is now enabled.
The ENABLE TX 1 command will enable TX 1. If TX 1 was disabled on power up TX 1 will again be disabled on
power up (or warm reset) unless you use SAVE STATUSES (Function number 87). If you ENABLE TX 1 and then
use the SAVE STATUSES function TX 1 will always be enabled when a power or warm reset occurs.
Summary of Contents for Linker IIa
Page 12: ...11...