Icom IC-R5, Instruction Manual

Page: 37 / 80

26
6
SCAN OPERATION
New2001
6
■
Full/band/programmed scan
q
Select VFO mode with [V/M•S.MW•
~
].
• Select the desired frequency band with [BAND• ], if desired.
w
Set the squelch to the point where noise is just muted.
e
Push [MODE•SCAN] for 1 sec. to enter scanning type se-
lection condition.
r
Rotate [DIAL] to select the desired scanning type.
• “ALL” for full scan; “BAND” for band scan, “PROGxx” for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
t
To start the scan, push [MODE•SCAN].
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• Push [MODE•SCAN] again to stop the scan.
NOTE: Instead of the steps
e
to
t
operations, while
pushing and holding [MODE•SCAN], rotate [DIAL] to se-
lect the desired scan type. In this case, scan starts when
releasing [MODE•SCAN].
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
FM SKIP P FM SKIP P
• During full/band scan • During programmed scan
[MODE•SCAN]
[DIAL]
• Full scan selection
• Band scan selection
• Programmed scan selection
Selectable between “ 0” to “24”
if programmed
IC-R5_1.qxd 02.10.23 11:29 Page 26 (1,1)