![background image](http://html1.mh-extra.com/html/icom/ic-e80d/ic-e80d_instruction-manual_4187689112.webp)
104
10
SCAN OPERATION
N
Full/band/programmed scan
q
Push
[V/MHz]
to select the VFO mode
.
• Select the desired frequency band with
[BAND]
, if desired.
w
Set the squelch level.
e
Push and hold
[SCAN]
(V/MHz) for 1 sec. to enter the scan-
ning type selection.
r
Rotate
[DIAL]
to select the desired scanning type.
• “ALL” for full scan; “BAND” for band scan, “P-LINK x” for pro-
grammed link scan (x= 0 to 9), “PROG
xx
(or scan name if pro-
grammed)” for programmed scan (
xx
= 0 to 24; only programmed
scan edge numbers are displayed), “DUP” (appears only when
duplex operation is set) for duplex scan.
[DIAL]
Full scan
Band scan
Programmed link scan
Push and hold
for 1 sec.
Programmed scan
Selectable from “0” to “9.”
Selectable from “0” to “24”
if programmed.
Rotate
t
Push
[V/MHz]
to start the scan.
• Scan pauses when a signal is received.
• Rotate
[DIAL]
to change the scanning direction. This also
causes the transceiver to resume scanning.
• Push
[V/MHz]
to stop the scan.
• Push
[BAND]
to change the band during band scan, or change
the scan edge during programmed scan/program link scan.
During full/band scan
During programmed scan
About the scanning steps:
The selected tuning step in each
frequency band (in the VFO mode) is used during scan.
Duplex scan function:
Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
Scan name can be displayed instead of “P-LINK x” for pro-
gram link scan (x= 0 to 9), “PROGxx” for programmed scan
(xx= 0 to 24) when scan name is programmed and set to ON
in DISP set mode.
MENU
¶
SET
¶
DISP
¶
SCAN N
(p. 129)
Scan name is not displayed during scan.
Summary of Contents for IC-E80D
Page 184: ...176 MEMO...
Page 185: ...177 MEMO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19...
Page 186: ...178 MEMO...
Page 187: ...179 MEMO 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19...