8
SET MODE
8-13
MENU
» SET > Connectors >
USB SEND/Keying
Inhibit Timer at USB Connection
(Default: ON)
Sets to prevent unintentional SEND or Keying signal
transmission, under the following conditions.
- When connecting a PC to the transceiver using a
USB cable.
- While the transceiver and a PC are connected
using a USB cable, or when starting up the PC or
connecting or disconnecting a USB device to or from
the PC.
- When a virtual serial port communication has been
established.
•OFF: The transceiver transmits the SEND or Keying
signal right after a PC or USB device is
connected.
•ON: The transceiver transmits after a few seconds
have passed, to prevent unintentional
transmission.
L
If you change this setting to “OFF,” update the transceiver’s USB
driver and make sure the SEND or Keying signal will not be
unintentionally transmitted.
MENU
» SET > Connectors >
External Keypad
VOICE
(Default: OFF)
KEYER
(Default: OFF)
RTTY
(Default: OFF)
Enables each memory (voice, keyer, RTTY)
transmission using an external keypad.
MENU
» SET > Connectors >
CI-V
CI-V Baud Rate
(Default: Auto)
Selects the CI-V data transfer rate.
L
When “Auto” is selected, the baud rate is automatically set
according to the data rate of the connected device.
CI-V Address
(Default: A2h)
Sets the CI-V address.
L
“A2h” is the default address of the IC-9700.
CI-V Transceive
(Default: ON)
Turns the Transceive function ON or OFF.
•OFF: The status is not output.
•ON: The status is output.
When you change a setting on the
transceiver, the same change is automatically
set on other connected transceivers or
receivers, and vice versa.
CI-V USB/LAN→REMOTE Transceive Address
(Default: 00h)
Sets the address used to remotely control the
transceiver or the receiver, through the [USB] port or
the [LAN] port.
The external equipment control signal is output from
the [REMOTE] jack.
CI-V USB Port
(Default: Unlink from [REMOTE])
Selects the internal connection type between the
[USB] and [REMOTE] CI-V ports.
•Link to [REMOTE]:
The [USB] and [REMOTE] CI-V ports are
internally connected.
•Unlink from [REMOTE]:
The [USB] and [REMOTE] CI-V ports are
not internally connected.
Each port functions independently.
CI-V USB Baud Rate
(Default: Auto)
Selects the CI-V data transfer rate when remotely
controlling the IC-9700 through the [USB] CI-V port.
L
When “Auto” is selected, the baud rate is automatically
set according to the data rate of the external device.
L
This setting is valid only when the “CI-V USB Port” item is
set to “Unlink from [REMOTE].”
CI-V USB Echo Back
(Default: OFF)
Turns the Data Echo Back function ON or OFF, when
remotely controlling the IC-9700 through the [USB]
CI-V port.
L
This setting is valid only when the “CI-V USB Port” item is
set to “Unlink from [REMOTE].”
CI-V DATA Baud Rate
(Default: OFF)
Selects the CI-V data transfer rate when remotely
controlling the IC-9700 through the [DATA] jack.
CI-V DATA Echo Back
(Default: OFF)
Turns the Data Echo Back function ON or OFF, when
remotely controlling the IC-9700 through the [DATA]
jack.
Connectors (Continued)
