![background image](http://html1.mh-extra.com/html/icom/i2730a/i2730a_instruction-manual_3821283087.webp)
82
13
MAINTENANCE
New2001
13
MAINTENANCE
New2001
■
Power protect function
The transceiver is equipped with a protection circuit for the
power amplifier. The circuit activates when the transceiver
continuously transmits at high power, and then the tempera-
ture becomes extremely high.
In this case, the transceiver automatically reduces transmit
output power to low (approximately 5 W).
When the Power protect function activates, wait until the
transceiver’s temperature returns to normal.
NOTE:
When the power supply voltage is over 17.0 V, the
transceiver automatically displays “OVER V,” and then
sounds a warning beep. In this case, the transceiver may
be damaged. If damage occurs, contact your nearest Icom
Dealer or Service Center.
■
Spurious signals
Spurious signals may occur at some frequencies. These are
created in the internal circuit and does not indicate a trans-
ceiver malfunction.
You may avoid the spurious signals with the IF exchange
function. (p. 15)
■
Fuse replacement
A fuse is installed in each fuse holder of the supplied DC
power cable. If a fuse blows, or the transceiver stops function-
ing, track down the source of the problem if possible, repair
it and then replace the damaged fuse with a new rated one
(FGB 15 A).
R
WARNING! NEVER
remove the fuse holders from the
DC power cable.
USE
only the applicable fuses.
NOTE:
Before replacing the fuse, be sure to disconnect the
DC cable from the power source.