![background image](http://html1.mh-extra.com/html/icom/i2730a/i2730a_instruction-manual_3821283045.webp)
New2001
40
5
SCAN OPERATION
New2001
5
SCAN OPERA
TION
!4
Rotate [DIAL]
S
to select a desired number.
!5
Push [
Ω
] to move the cursor backwards, or push [
≈
] to
move the cursor forwards.
!6
Repeat steps
!4
and
!5
to enter a lower edge frequency.
(Example: 375.000)
!7
After entering, push [
ï
]
D
.
Lower edge frequency
setting screen
!8
Rotate [DIAL]
S
to select “FREQ H,” and enter a higher
edge frequency in the same way as steps
!3
and
!5
.
!9
After entering, push [
ï
]
D
.
Setting a tuning step
3.
NOTE:
If the frequencies entered in “FREQ L” and “FREQ H”
are on a different band, the Tuning step setting screen does
not appear. In this case, the VFO mode’s tuning step for each
band is used during a scan.
@0
Rotate [DIAL]
S
to select “TS.”
@1
Push [
ï
]
D
to display the Tuning step setting screen.
@2
Rotate [DIAL]
S
to select a desired tuning step to be used
while program scanning.
Selectable value:
5 kHz, 6.25 kHz, 8.33 kHz*, 10 kHz, 12.5 kHz, 15 kHz,
20 kHz, 25 kHz, 30 kHz, 50 kHz, or AUTO*.
*Appears only when the AIR band is selected.
@3
After selecting, push [
ï
]
D
.
Setting a operating mode
4.
NOTE:
•
If the frequencies entered in “FREQ L” and “FREQ H” are
on a different band, the Operating mode setting screen
does not appear. In this case, the VFO mode’s operating
mode for each band is used during a scan.
•
When the entered frequencies are in the AIR band, the op-
erating mode is automatically set, and the setting screen
does not appear.
@4
Rotate [DIAL]
S
to select “MODE.”
@5
Push [
ï
]
D
to display the Operating mode setting screen.
@6
Rotate [DIAL]
S
to select a desired operating mode.
@7
After selecting, push [
ï
]
D
.
Entering the scan edge
5.
@8
Rotate [DIAL]
S
to select “WRITE.”
@9
Push [
ï
]
D
.
• Displays “WRITE?.”
#0
Rotate [DIAL]
S
to select “YES.”
#1
Push [
ï
]
D
.
• Beeps sound.
• Enters the scan edges, and returns to the Scan edge channel
select screen.
The
C
,
S
, or
D
in the instructions indicate the area of the
controller.
C
: Center,
S
: Side,
D
: Display