iCharger 1010B, User Manual

Page: 17 / 22

-17-
iCharger Synchronous Balance Charger/Discharger 1010B/106B
Electric motor drive
You can easily break-in new brushed electric motors using a variable voltage and running time. Note that
the iCharger cannot directly drive brushless DC motors and that brushless motors do require or
benefit from a breaking-in process.
With this function you also check the motor performance to optimize
your power-train. The break-in process is essential for maximizing the power of a new brushed motor. New
motors have square brushes which press up against the curved commutator. The goal for the break-in
process is to gentle shape the brushes so that they develop a curved surface that fits snugly against the
commutator giving greater conducting surface area and hence lower losses and higher efficiency.
The value on the right side of the first line sets the test duration in minutes.
The second line shows the upper limit of current on the left and drive
voltage on the right. After setting the current and voltage press
Start/Enter
for more than 3 seconds to start the next process. A beep tone will sound.
Test time: 1 – 90 min, Current: 0.05 – 10A, Test voltage: 1 – 15V
Status display. The top line shows the drive current and voltage. The
second line shows the output capacity (mAh) and in the the lower right
corner alternately displays the output power or total run time. You can stop
the test at any time by pressing
Batt type/Stop .
Start/Enter
>3 seconds
Batt type
Stop
MOTO 1.9A 2.05V
MOTO 1.9A 2.05V MOTO 1.9A 2.05V
MOTO 1.9A 2.05V
DRV 00310 3.8W DRV 00310 3.8W DRV 00310 3.8W DRV 00310 3.8W
drive
voltage
drive
capacity
power
or time
drive
current
work
state
motor
test
MOTOR MOTOR MOTOR MOTOR DRV 10 DRV 10 DRV 10 DRV 10min min min min
8.0A 2.0V 8.0A 2.0V 8.0A 2.0V 8.0A 2.0V
-
Dec
+
Inc
-
Dec
+
Inc