IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 194 / 258

Error code/symptom FRU/action
162 (Device Configuration Error)
Note: Be sure to load the default settings and
any additional desired settings; then, save
the configuration
1. Run Configuration/Setup
2. Battery
3. Failing device
4. I/O board
163 (Real-Time Clock error)
1. Run Configuration/Setup.
2. Battery.
3. I/O board.
164 (Memory configuration changed, see
“Memory settings” on page 18.)
1. Run Configuration/Setup.
2. DIMM.
3. SMP board.
175 (Hardware error)
1. SMP board
2. I/O board
3. Service processor
177, 178 (Security hardware error)
1. Run Configuration/Setup.
2. I/O board.
3. Service processor.
184 (Power-on password corrupted)
1. Run Configuration/Setup.
2. Battery.
3. I/O board.
185 (Drive startup sequence information
corrupted)
1. Run Configuration/Setup.
2. I/O board.
186 (Security hardware control logic failed)
1. Run Configuration/Setup.
2. I/O board.
3. Service processor.
187 (VPD serial number not set.)
1. Set serial number in Setup.
2. I/O board.
3. Service processor.
188 (Bad EEPROM CRC #2)
1. Run Configuration/Setup.
2. I/O board.
3. Service processor.
189 (An attempt was made to access the
server with invalid passwords)
v Run Configuration/Setup, enter the administrator password.
201 (memory controller test)
1. DIMM
2. SMP board
289 (DIMM has been disabled by the user or
system, see “Memory settings” on page 18.)
1. Run Configuration/Setup, if disabled by user.
2. Disabled DIMM, if not disabled by user.
301 (Keyboard or keyboard controller error)
Note: After installing a USB keyboard, you
might need to use the Configuration/Setup
Utility program to enable keyboardless
operation and prevent the POST error
message 301 from being displayed during
startup.
1. Keyboard
2. Centerplane
3. I/O board
182
xSeries 440 Type 8687: Hardware Maintenance Manual