IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 138 / 258

8. Remove the shipping screw (
2
) from the left side of the server, if installed.
9. Disconnect all cables attached to the PCI brick.
10. Disconnect the cables to the DASD backplane (see “DASD backplane” on
page 140).
Note: Failure to disconnect the DASD backplane cables may result in the PCI
brick becoming entangled in these cables at step 12.
11. Pivot the release handle (
3
).
12. Slide the PCI brick as far forward as possible, and then slightly to the right
(
4
).
13. Lift the PCI brick straight up and out of the server (
5
).
14. To reinstall the PCI brick, reverse the above steps.
Note: The PCI brick connects to the chassis with tabs that connect with seven
slots on the bottom of the chassis and two slots on the side of the
chassis. Line up the tabs on the PCI brick with the slots on the chassis,
and then slide the PCI brick into place.
126
xSeries 440 Type 8687: Hardware Maintenance Manual