IBM xSeries 440 8687, Hardware Maintenance Manual

Page: 174 / 258

Service Processor message FRU/action
System shutoff due to CPU x over
temperature
1. Heat sink
2. Fans
System shutoff due to DASD x temperature
1. SCSI drives
2. Fans
3. SCSI backplane
System shutoff due to high ambient
temperature
1. Check room temperature.
2. Fans.
3. Light Path assembly.
Uncorrectable Cache Error Detected.
Removed Failed Component(s) from active
configuration.
v Run diagnostics.
Uncorrectable memory error on bank Jxx
v Run memory diagnostics.
VRM x Power Good Fault
v VRM
The service processor also generates a large number of information, error and
warning messages.
If an RXE-100 unit is attached, the service processor may generate further
messages specific to this unit. These are listed in the following table and are
intended to be self-explanatory.
Diagnostic error codes
Note: In the following error codes, if xxx is 000 , 195 , or 197, do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to abort the test.
197 This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
Error code/symptom FRU/action
001-198-000 (Test Aborted)
1. Check error log for messages.
2. Run Quick Memory Test All Banks.
3. Reload system BIOS and rerun test.
001-250-000 (Test aborted)
1. Check error log for messages (see “Error logs” on page 54).
2. SMP board
001-250-001 (Failed SMP Expansion Board
ECC)
1. Check error log for messages (see “Error logs” on page 54).
2. SMP board 1 (bottom).
001-250-002 (Failed SMP Expansion Board
ECC)
1. Check error log for messages (see “Error logs” on page 54).
2. SMP board 2 (top).
001-250-099 (Failed SMP Expansion Board
ECC)
1. Check error log for messages (see “Error logs” on page 54).
2. SMP board 1 (bottom) and 2 (top).
162
xSeries 440 Type 8687: Hardware Maintenance Manual