IBM x 340 Series, Hardware Maintenance Manual

Page: 65 / 188

Installing options
57
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then remove the cover (see “Removing the cover and bezel” on page
47).
3. Remove the air baffle by grasping it at the sides and lifting it from the server.
4. Remove the terminator card from the microprocessor connector. Store the
terminator card in a safe place in the static-protective package that your new
microprocessor is shipped in; you will need to install it again, if you ever remove
the microprocessor.
5. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to any
unpainted metal surface on the server; then, remove the microprocessor from
the package.
b. Center the microprocessor over the microprocessor connector and carefully
press the microprocessor into the connector.
Note: To remove a microprocessor, pull upward on the microprocessor handle.
6. Install the VRM included in the microprocessor kit.
Attention: When installing or replacing a VRM, use only a VRM specified for
use with the xSeries 340 server. Use of other VRMs might cause your
server to overheat.
a. Center the VRM over the VRM connector. Make sure that the VRM is oriented
and aligned correctly.
b. Press the VRM into the connector.
Note: If you remove the microprocessor later, remember to install the terminator
card in the appropriate microprocessor connector and to remove the VRM.
7. If you replaced the microprocessor with a different speed microprocessor, change
switches 1-4 on the switch block to the appropriate settings, as shown in the
following table.
8. Install the air baffle. Make sure the sides of the air baffle fit inside the brackets on
the server.
9. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 60.
Installing a hot-swap power supply
Your server comes with one power supply. You can install an additional power
supply.
Note: You do not need to turn off the power to the server to install a hot-swap power
supply.
Table 10. Microprocessor speed settings.
Microprocessor
speed
Switch 1 Switch 2 Switch 3 Switch 4
733/133 On Off Off Off
800/133 Off On On On