IBM x 340 Series, Hardware Maintenance Manual

Page: 31 / 188

Diagnostics
23
NDIS 4.0 (Windows NT) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation and
recommended action are included with each message.
PCNTND-15 Device not found.
Explanation:
The driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic programs” on page 14 to run the diagnostic
programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic programs” on page 14 to run the diagnostic
programs.
PCNTND-21 The adapter failed the checksum test.
Explanation: The driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic programs” on page 14 to run the diagnostic
programs.
PCNTND-23 WARNING: PCNET IRQ found =
xx
Explanation: The interrupt request (IRQ) setting (xx) in the PROTOCOL.INI file does
not match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match the
IRQ setting shown in the PCI Slot/Device Information selection of the Advanced Setup
menu in the Configuration/Setup Utility program.
PCNTND-24 WARNING: PCNET IRQ does not match PROTOCOL.INI.
Explanation: The interrupt request (IRQ) setting in the PROTOCOL.INI file does not
match the hardware IRQ setting. Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ setting in the PROTOCOL.INI file to match the
IRQ setting shown in the PCI Slot/Device Information selection of the Advanced Setup
menu in the Configuration/Setup Utility program.
PCNTND-25 PCI scan specified, PCI bus not found!
Explanation: The driver cannot locate the PCI bus. Action: Run
the diagnostic programs.
PCNTND-29 WARNING: DMA number is not necessary for PCI device.
Explanation:
The Ethernet controller does not require a DMA setting.
Action: Remove the DMA setting in the PROTOCOL.INI file.
PCNTND-33 PCNET device with specified IOBASE is already in use.
Explanation: The specified I/O address number is already in use by another Ethernet
controller or device.
Action:
Remove the I/O address setting in the PROTOCOL.INI file.
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.