IBM x 340 Series, Hardware Maintenance Manual

Page: 30 / 188

22
Hardware Maintenance Manual: xSeries 340 Model 6RY
Network driver interface specification 2.01 (OS/2) driver
messages
This section provides explanations of the error messages for the NDIS 2.01 (OS/2)
drivers, and suggested actions to resolve each problem.
PCNTNW-NW-165 The device was not found at IOADDRESS.
Explanation:
The Ethernet controller cannot be found at the I/O address
specified.
Action:
The Ethernet controller does not require a parameter for the I/O
address. Remove the I/O address parameter.
PCNTNW-NW-167 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the problem persists,
go to “Starting the diagnostic programs” on page 14 to run the diagnostic
programs.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: None necessary, message is for information only.
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.
PCNTND-1 Unable to open the Protocol Manager .
Explanation: The NDIS stack is not configured correctly. Action: Check
and correct your configuration.
PCNTND-6 Out of memory while allocating buffers.
Explanation: The driver could not allocate the requested buffers. Action:
Check your system configuration. Edit the PROTOCOL.INI file to reduce the number of
Txbuffers and Rxbuffers specified for the driver.
PCNTND-7 A Protocol Manager device error occurred.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-8 Bad status for the Protocol Manager.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-11 Protocol Manager registration failed.
Explanation: The NDIS stack is not configured correctly. Action: Check and correct
your configuration.
Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller.