IBM x 340 Series, Hardware Maintenance Manual

Page: 131 / 188

Symptom-to-FRU index
123
1301 (I
2
C cable to front panel not
found)
1. Cable
2. Front Panel
3. Power Switch Assembly
4. System Board
1302 (I
2
C cable from system board
to power on and reset switches not found)
1. Cable
2. Power Switch Assembly
3. System Board
1303 (I
2
C cable from system board
to power backplane not found)
1. Cable
2. Power Backplane
3. System Board
1304 (I
2
C cable to diagnostic LED
board not found)
1. Power Switch Assembly
2. System Board
1600 (The Service Processor is not
functioning) Do the
following before replacing a FRU:
1. Ensure that a jumper is not installed
on J45.
2. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
1. System Board
1601 (The system is able to
communicate to the Service Processor, but
the Service Processor failed to respond at
the start of POST.) Do the following
before replacing a FRU:
1. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
2. Flash update the Service Processor.
1. System Board
1762 (Fixed Disk Configuration error) 1. Fixed Disk Drive
2. Fixed Disk Cables
3. Run Configuration/Setup
4. Fixed Disk Adapter
5. SCSI Backplane
6. System Board
178X (Fixed Disk error) 1. Fixed Disk Cables
2. Run Diagnostics
3. Fixed Disk Adapter
4. Fixed Disk Drive
5. System Board
Error Code/Symptom FRU/Action