IBM Ultrastar 36LZX, Specifications

Page: 208 / 249

10.4.6 INITIATOR DETECTED ERROR Message
An INITIATOR DETECTED ERROR message is valid after a COMMAND, DATA IN/OUT or STATUS
phase has occurred. If another phase has occurred, the message is rejected.
The drive will, depending on the model, optionally retry the previous phase if it is command or status. If
this fails or the previous phase was a data transfer the drive will generate a CHECK CONDITION status
and a Sense key of ABORTED COMMAND with additional sense code of INITIATOR DETECTED
ERROR.
10.4.7 MESSAGE REJECT Message
The drive will take the following actions after receiving the MESSAGE REJECT message in response to
messages listed below.
DISCONNECT The drive is not disconnect but remains connected.
COMMAND COMPLETE No error, continue to bus free.
IDENTIFY Command aborted - bus freed - Sense data set to MESSAGE REJECT
ERROR.
LINKED CMD CMPLT Command aborted - link broken - bus freed - sense data set to
MESSAGE REJECT ERROR.
MESSAGE REJECT Command aborted - STATUS phase executed with CHECK CONDITION
- sense data set to MESSAGE REJECT ERROR.
RESTORE POINTERS Command aborted - status set to CHECK CONDITION - sense will be
set with the error that caused the RESTORE POINTERS message to be
issued. (Assuming that error recovery is in progress)
SAVE DATA POINTER The drive will not disconnect from the SCSI bus and tt will not be con-
sidered an error.
No previous Msg The command is aborted, the bus freed, and Sense data is set to
MESSAGE REJECT ERROR. This occurs when the drive has not sent a
message, but gets a MESSAGE REJECT from the initiator.
Ultrastar 36LZX hard disk drive specifications
208