IBM SAN04M-R, Installation And Service Manual, Page: 79 / 96

© Copyright IBM Corp. 2007 55
Chapter 5: Removal and replacement procedures
Use the links below to access the major topics in this chapter.
Procedural notes
Before removing a small form factor pluggable (SFP) optical
transceiver, read this:
1. Before removing the FRU, read the removal and replacement
procedures for that FRU carefully and familiarize yourself with
the procedures and reduce the possibility of problems or
customer down time.
2. After replacing the FRU, clear any error messages reporting the
failure and any message reporting the recovery from the Element
Manager or SANvergence Manager and extinguish the system
error (
SYS
) light-emitting diode (LED) at the front panel.
Replace SFP optical transceiver
Section Page
Procedural notes
55
Replace SFP optical transceiver
55
SFP optical transceivers can be removed and replaced while the SAN
Router is powered on and operational.
Use the following procedures to remove or replace an SFP optical
transceiver from the front of the router chassis. Refer to
Chapter 4,
Parts catalog
, for FRU locations and part numbers.
Tools required
The following tools are required to perform these procedures.
• Door key with 5/16-inch socket (only for some equipment
cabinets).
• Protective cap (provided with the fiber-optic jumper cable).