IBM SAN04M-R, Installation And Service Manual, Page: 41 / 96

17 Chapter 2: Installing and connecting the SAN Router
Refer to Table 6 for the default setting for the Management Port IP
address, which is the only IP address that must be changed using CLI
to provide access for out-of-band management. All other default
setting can be changed using the Element Manager.
To set the SAN Router IP address, you can use one of three methods:
1. Connect a terminal to the RS-232 port on the SAN Router as
described in
Task 5: Connecting the VT100 or emulation terminal to
the RS-232 management port
on page 18.
2. Access the router using the Telnet protocol.
3. Access the router embedded Web-based management on the
10/100 management port using the default management IP
address.
Table 6
Default Management and SAN Router addresses
Port IP Address Subnet Mask Default Gateway
Mgmt 192.168.100.100 255.255.255.0 0.0.0.0
SAN Router
inband 192.168.110.100 255.255.255.0 0.0.0.0
Table 7 Default TCP port addresses
Port Internal IP Address Comment
3 192.168.111.103
(255.255.255.0)
User must set up the port IP address, subnet
mask and external router address.
4 192.168.111.104
(255.255.255.0) User must set up the port IP address, subnet
mask and external router address.
Table 8 Other SAN Router defaults
Parameter Default Setting
Zoning No Zone (No devices zoned by default)
mSAN ID 0
FC Port Type FC - Auto
Intelligent Port Interface Fast Ethernet (RJ45)