IBM SAN04M-R, Installation And Service Manual, Page: 59 / 96

35 Chapter 2: Installing and connecting the SAN Router
NOTE:
If the SAN Router is shipped pre-installed in a cabinet, the default IP
address is set during the cabinet configuration process to 10.xx.yy.zz where:
xx is the cabinet number, yy is the product type identifier, which for the SAN
Router is 16, and zz is the position in the cabinet, from bottom to top.
Table 15 SAN Router firmware default values via SANvergence
SANvergence parameters Default setting SANvergence menu hierarchy
R_Port and fabric configuration
Fabrics
Fabric Fabric-ID 1 SAN Configuration>Actions>Fabric
Configuration>Fabrics
Preferred Domain ID 1 SAN Configuration>Actions>Fabric
Configuration>R_Ports
Insistent Domain ID Disabled SAN Configuration>Actions>Fabric
Configuration>R_Ports
Enable Port Binding Disabled SAN Configuration>Actions>Fabric
Configuration>R_Ports
Bound Node WWN 00:00:00:00:00:00:00:0
0 SAN Configuration>Actions>Fabric
Configuration>R_Ports
Selective import
Discovered Devices for Fabric 1-Fabric-ID 1 SAN Configuration>Actions>Fabric
Configuration>Selective Import
General
Enable LUN Mapping Disabled mSAN Configuration>Actions>Enable LUN
Mapping
New zone
Zone ID Next available number
up to 512 mSAN Configuration>Actions>New Zone
Minimum Guaranteed Bandwidth 150 kbps mSAN Configuration>Actions>New Zone
Maximum Allowed Bandwidth 1, 000,000 kbps mSAN Configuration>Actions>New Zone