IBM SAN04M-R, Installation And Service Manual, Page: 39 / 96

15 Chapter 2: Installing and connecting the SAN Router
The SAN Router has no power switch and will power up when it is
connected to a live power source. Either power supply can maintain
power for the SAN Router; however, we recommend connecting both
power supplies, each to a separate power source, for redundancy
protection.
1. To power up the SAN Router: locate the power connections on
the front of the SAN Router. See Figure 2,
Power connections and
LEDs
.
DANGER
Use the supplied power cords. Ensure the facility power receptacle is
the correct type, supplies the required voltage, and is properly
grounded.
2. Connect the power cord to the SAN Router and to a live power
outlet.
3. Repeat for the second power cord.
NOTE:
You should maintain reliable earthing of the rack-mounted
equipment. Pay particular attention to the supply connections other than the
direct connections to the branch current (for example, when using power
strips)