IBM MTM 2145-12F, Hardware Installation Manual

Page: 55 / 214

a. Open the front latch hook (
▌1▐
).
b.
Fit the tool-less rail-mounting pin to the front rack post (
▌2▐
).
c. Click the rail-mounting pin into place (
▌3▐
).
d. Close the front latch hook (
▌4▐
).
7. Install the outer section of the rail to the rear frame, as shown in Figure 21 on
page 20.
a. Open the rear latch hook (
▌5▐
).
b. Click the rear bracket into place on the rear frame (
▌6▐
).
c. Close the rear latch hook (
▌7▐
).
8. Using an M5 x 10 mm screw and M5 washer, anchor the front bracket to the
front frame (
▌8▐
).
9. Using an M5 x 10 mm screw and M5 washer, anchor the rear bracket to the
rear frame (
▌9▐
).
10.
Repeat steps 6 on page 20-9 for the opposite rail.
Installing the SAN Volume Controller 2145-SV1 in a rack
After you install the support rails, you can install the SAN Volume Controller
2145-SV1 node in the rack.
Before you begin
CAUTION:
To avoid any hazard from the rack tipping forward when devices are installed,
observe all safety precautions for the rack into which you are installing the
device.
CAUTION:
The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb). It
takes two persons to safely lift this part or unit. (C009)
Procedure
To install the SAN Volume Controller 2145-SV1 node in the rack, complete the
following steps.
1. Fully extend the middle section of the rail from the outer section on both sides
and lock it in place.
Chapter 2. Installing the SAN Volume Controller 2145-SV1 hardware
21