IBM Magstar MP 3570 C Series, Maintenance Information

Page: 501 / 675

Figure 305 (Page 4 of 5). ATTENTION LIBRARY Messages
Message
Meaning
FRUs FRU Name or Description Prob-
ability
TAC
Code &
(Duration
in hours)
Page Reference or Instruction
Magazine
Full
The magazine is full of cartridges. The device detected that the magazine cannot hold any more cartridges.
Note: Before replacing FRUs below, ensure that the priority cell, picker, and cartridge present sensors are
operating correctly. See Figure 128 on page PANEL-26 and select UTILITIES from the CE OPTIONS
Menu, then select DISP SENSORS from the CE UTILITIES Menu.
FD Cartridge magazine 95% Q05 (0.1) Remove the magazine and
replace the cartridges or insert
another full magazine.
9A Picker assembly 4% T12 (0.1) APPENDD-43
97 Library control card 1% T15 (0.1) APPENDD-42
Library
Not
Enabled
Ensure there are cartridges in the library and that they are seated in the import position.
9E Priority cell cartridge-present
sensor 48% T31 (0.1) APPENDD-52
9A Picker assembly 34% T12 (0.1) APPENDD-43
A5 Library sensor cable 10% T04 (0.4) APPENDD-54
97 Library control card 5% T15 (0.1) APPENDD-42
Feed
Over-
current
An over-current condition was detected in the library feed motor circuitry.
97 Library control card 60% T15 (0.1) APPENDD-42
9A Picker assembly 20% T12 (0.1) APPENDD-43
Pinch
Over-
current
An over-current condition was detected in the library pinch motor circuitry.
APPENDB
97 Library control card 60% T15 (0.1) APPENDD-42
9A Picker assembly 20% T12 (0.1) APPENDD-43
Picker
Over-
current
An over-current condition was detected in the library picker motor circuitry.
97 Library control card 60% T15 (0.1) APPENDD-42
9A Picker assembly 20% T12 (0.1) APPENDD-43
Transport
Full
The picker attempted to unload a cartridge but had no place to put it. A tape cartridge is present in slot that the
device tried to unload to, or it appears to the machine that the slot is full. Could be a full slot or a sense error.
The tape cartridge was left in the transport.
1. Ensure that a cartridge was not placed in an in use cell, causing this failure.
2. Before replacing FRUs below, ensure that the priority cell, picker, and cartridge present sensors are operating
correctly. See Figure 128 on page PANEL-26 and select UTILITIES from the CE OPTIONS Menu, then
select DISP SENSORS from the CE UTILITIES Menu.
FE Tape cartridge 70% — (0.1) Remove the cartridge
9A Picker assembly 20% T12 (0.1) APPENDD-43
97 Library control card 6% T15 (0.1) APPENDD-42
FD Magazine 4% Q05 (0.1) Check magazine for defect.
AppendB
APPENDB-27