IBM LS21 - BladeCenter - 7971, Service Manual

Page: 101 / 130

Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
battery.
2. Insert the battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
the battery clip holds the battery securely.
3. Install the MPE unit, if one was removed while removing the battery (see
“Installing an expansion unit” on page 71).
4. Install the blade server cover (see “Installing the blade server cover” on page
69).
5. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 66).
6. Turn on the blade server and run the Configuration/Setup Utility program. Set
configuration parameters as needed (see “Using the Configuration/Setup Utility
program” on page 97 for information).
Chapter 4. Removing and replacing blade server components
85