IBM Intellistation POWER 9112 265, User Manual

Page: 156 / 227

If the serviceable event was not the result of an error log entry, use the Log Repair
Action task to turn off the system fault indicator.
Refer to the system unit service guide for additional information concerning the use of
this indicator.
Note: The AIX command does not allow you to set the system fault indicator to the
Fault state.
Use the following example to run this task directly from the AIX command line:
/usr/lpp/diagnostics/bin/usysfault [-s normal]
Flag Description
-s Normal, sets the system fault indicator to the Normal state.
When this command is used without the -s flag, the current state of the indicator
displays.
System Identify Indicator
This task is used to display or set the system identify indicator on systems that support
this function.
The system identify indicator is used to help physically identify a particular system in
group of systems. Refer to the system unit service guide for additional information
concerning the use of this indicator.
Use the following example to run this task directly from the AIX command line:
/usr/lpp/diagnostics/bin/usysident [-s {normal | identify}]
Flag Description
-s {normal | identify} Sets the state of the System Identify Indicator to
either Normal or Identify.
When this command is used without the -s flag, the current state of the indicator
displays.
Update Disk-Based Diagnostics
This service aid allows fixes (APARs) to be applied.
This task invokes the SMIT Update Software by Fix (APAR) task. The task allows the
input device and APARs to be selected. Any APAR can be installed using this task.
136
User’s Guide