IBM IntelliStation 6836, Hardware Maintenance Manual

Page: 70 / 164

Complete the following steps to install the computer cover:
1.
Clear any cables that might impede the replacement of the cover.
2. Install the side cover by placing it into position on the computer. Close the
cover release latch to secure the cover in place.
3. Lock the cover.
4. If you have not done so already, make sure that the two front stabilizing feet
are rotated outward so that they properly support the computer. Rotate each
individual foot outward 90 degrees.
5. Reconnect the external cables and power cords to the computer; then, plug the
power cords into electrical outlets.
6.
Turn on the attached devices; then, turn on the computer.
Connecting external options
You can attach a SCSI storage expansion enclosure to your computer.
Installation procedure
To attach an external device:
1. Read “Before you begin” on page 29 and the documentation that comes with
your options.
2. Be sure your computer and all attached devices are turned off.
3. Follow the instructions that come with the option to prepare it for installation
and to connect it to the computer.
Note: If you are attaching a SCSI device, see “Ultra 3/160 SCSI connector
(some models)” on page 66 for SCSI ID and cabling information.
Input/Output ports Types 6836 and 6846
This section provides information about the I/O connectors on the rear of your
computer. These connectors include the following:
v
One mouse
v
One keyboard
v
One parallel
v
Two serial
v
One Ethernet
v
Two USB
v
Line out
v
Line in
v
Mic
v
MIDI
v
One video
v
One Ultra 3/160 SCSI (some models)
Mouse connector
The system board has one mouse connector that supports a mouse or other
pointing device. The mouse connector is located on the rear of your computer, see
62
Hardware Maintenance Manual: IBM IntelliStation Type 6836, 6846