IBM IntelliStation 6836, Hardware Maintenance Manual

Page: 101 / 164

Diagnostic Error Code FRU/Action
011-027-XXX Serial port Configuration/Setup
error
1. Run Setup, enable port
2. Flash the system
3.
System board
011-03X-XXX 011-04X-XXX
Serial port failure
1. System board
011-195-XXX Serial port Test aborted by user
1.
Information
2.
Re-start the test, if necessary
011-196-XXX Serial port test halt, error
threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
011-197-XXX Serial port test warning
1. Make sure the component that is called
out is connected and/or enabled
2. Re-run test
3.
Component that is called out in warning
statement
4. Component under test
011-198-XXX Serial port test aborted
1.
If a component is called out, make sure
it is connected and/or enabled
2. Flash the system and re-test
3. Go to the
″
Undetermined problems
″
section
011-199-XXX Serial port test failed, cause
unknown
1. Go to the
″
Undetermined problems
″
section
2. Flash the system and re-test
3. Replace component under function test
011-2XX-XXX Serial port signal failure
1. External serial device
2.
System board
014-000-XXX Parallel port Interface Test
Passed
1. No action
014-001-XXX Parallel port Presence
1. Remove external parallel device, if
present
2. Run setup, enable port
3. System board
014-002-XXX 014-003-XXX Parallel port
Timeout/Parity error
1. System board
014-013-XXX 014-014-XXX Parallel port
Control Signal/Loopback test failure
1. System board
014-015-XXX Parallel port External Loopback
failure
1. Wrap plug
2. System board
014-027-XXX Parallel port
Configuration/Setup error
1. Run Setup, enable port
2. Flash the system
3. System board
014-03X-XXX 014-04X-XXX Parallel port
failure
1. System board
014-195-XXX Parallel port Test aborted by
user
1. Information
2. Re-start the test, if necessary
Chapter 7. Symptom-to-FRU index
93