IBM HS40 - BladeCenter - 8839, Setup Manual

Page: 20 / 64

e. If your blade server does not support PXE/BOOTP booting or installation
and SOL on Planar Ethernet 1 at the same time, select
Start Options ; then,
set the following values:
v
Planar Ethernet PXE/DHCP to Planar Ethernet 2
v
Run PXE only on selected Planar NIC to Enabled
f. Press Esc to exit the Start Options section of the Configuration/Setup Utility
program.
g. Select Save Settings ; then, press Enter.
h. Press Enter to confirm.
i.
Select
Exit Setup
; then, press Enter.
j. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.
14
BladeCenter: Serial over LAN Setup Guide