IBM HS40 - BladeCenter - 8839, Setup Manual

Page: 10 / 64

Checking firmware versions
Complete the following steps to view the firmware levels that are installed in the
BladeCenter components:
1. Start the BladeCenter management-module Web interface (see “Starting the
BladeCenter management-module Web interface” on page 5).
2. In the navigation pane, click Monitors → Firmware VPD .
The Firmware VPD choice identifies the firmware type, build ID, release date, and
revision number for the firmware that is installed in each blade server, I/O
module, and management module in the BladeCenter unit. The vital product data
(VPD) for the firmware in the management modules also includes the file name of
the firmware components. (Selecting the Firmware VPD choice takes up to 30
seconds to refresh and display information.)
Important: To avoid problems and to maintain proper system performance, always
make sure that the blade server firmware code, service processor code, and
diagnostic firmware code levels are consistent for all blade servers within the
BladeCenter unit.
Compare the installed firmware version to the information in Table 1 on page 3
and to the firmware information at http://www.ibm.com/support/. If the
firmware version installed is at or above the version listed in Table 1 on page 3,
your BladeCenter component has the firmware code needed to use the SOL
feature. If installed firmware versions do not meet at least the minimum
requirements, download the latest firmware code from http://www.ibm.com/
support/ and install it following the firmware update instructions in Chapter 4,
“Special component requirements,” on page 25.
4
BladeCenter: Serial over LAN Setup Guide