IBM HS40 - BladeCenter - 8839, Installation And User Manual

Page: 59 / 120

Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
3. Reinstall the blade server into the BladeCenter unit (see “Installing the blade
server in the BladeCenter unit” on page 47).
4. Turn on the blade server (see “Turning on the blade server” on page 17).
Note: Reinstall the bezel assembly on the BladeCenter T unit after you have
finished installing the blade servers (see the BladeCenter T Types 8720 and
8730 Installation and User’s Guide for detailed instructions about reinstalling the
bezel assembly). However, if you installed an option such as a PCI I/O
Expansion Unit with PCI adapters that require cables, you will not be able to
install the bezel assembly, which contains an air filter for the BladeCenter T unit.
If you require an air filter, a filter must be provided on the rack.
5. For certain options, run the blade server Configuration/Setup Utility program
(see “Updating your blade server configuration” on page 50).
Note: If you have just connected the power cords of your BladeCenter unit to
electrical outlets, you will have to wait until the power-on LED on the blade server
flashes slowly before pressing the power-control button on a blade server.
Installing the blade server bezel assembly
Complete the following steps to install the blade server bezel assembly.
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 21.
2. Connect the control-panel cable to the control-panel connector on the processor
board.
Control-panel
cable
Control-panel
connector
Chapter 3. Installing options
45