6
IBM® xSeries 330: Installation Guide
The following illustration shows the location of the 33 MHz PCI expansion slots on the
system board.
Adapter considerations
Before you install adapters, review the following:
•
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this chapter. If you need to change the
switch settings or jumper settings on your adapter, follow the instructions that
come with the adapter.
•
You can install 32-bit or 64-bit full-length or half-length adapters in the expansion
slots. Full-length adapters are installed in slot 1; half-length adapters are installed
in either slot 1 or 2.
•
Your server supports 5.0 V and universal PCI adapters; it does not support 3.3 V
only adapters.
•
Your server uses a rotational interrupt technique to configure PCI adapters. You
can use this technique to install PCI adapters that currently do not support
sharing of PCI interrupts.
•
PCI slots 1 and 2 and the integrated SCSI controller are on PCI bus B; the system
board and all other integrated devices are on PCI bus A.
Note: PCI bus A is bus 0; PCI bus B is bus 1.
•
The system scans PCI slots 1 and 2 to assign system resources. By default, the
system starts (boots) devices in the following order: system IDE and SCSI
devices, then PCI devices.
Note: To change the startup order, start the Configuration/Setup Utility program,
and select Start Options from the main menu. Then, select the PCI SCSI
adapter boot option.
PCI slot 1
64 bit
33 MHz (J10)
PCI slot 2
64 bit
33 MHz (J23)
Summary of Contents for eServer 330 xSeries
