IBM BladeCenter JS20, Installation And User Manual

Page: 85 / 132

Table 1. Abbreviated list of firmware error codes (continued)
Error code Failing device or problem found Suggested action
25A80210 Setenv/$Setenv parameter error;
name contains a null character.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80211 Setenv/$Setenv parameter error;
value contains a null character.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80998 NVRAMRC script evaluation error. Perform the following steps to remove the NVRAMRC
script:
1. Boot to the open firmware prompt.
2. Enter the following command:
0 0 " nvramrc" $setenv
If the problem remains, contact your system administrator
for assistance.
25A80999 NVRAMRC script evaluation error;
stack unbalanced on completion.
This is a firmware debug environment error. No action is
required. No component replacement is required.
If the problem remains, have the blade server serviced.
25000000 The blade server failed to set the
Write Delay (WRDLY) bit in the
memory controller register.
1. Start from the PERM flash image to reflash the TEMP
image for recovery. See “Recovering the system
firmware code” on page 84.
2. If the problem remains, replace the blade server.
Contact a service support representative for
assistance.
25C00000 No DIMMs were detected. Note: For additional information about DIMMs, see
“Installing memory modules” on page 24.
1. Make sure that the DIMMs are correctly seated. If
necessary, reseat the DIMMs.
2. Restart the blade server.
3. Perform the system checkout procedure. See “System
checkout” on page 48.
If the problem remains, replace the system-board
assembly. Contact a service support representative for
assistance.
Chapter 7. Solving problems
73