IBM BladeCenter JS20, Installation And User Manual

Page: 78 / 132

Table 1. Abbreviated list of firmware error codes (continued)
Error code Failing device or problem found Suggested action
20A80005 The trivial file transfer protocol
(TFTP) failed.
1. Make sure that the BOOTP server is correctly
configured for this client.
2. Check the network connection. If the network
connection is good, retry the operation. If there is no
network connection, contact your network
administrator.
3. If there are no problems with the BOOTP server or the
network connection, replace the system-board
assembly. Contact a service support representative for
more information.
20A80006 The startup image is too large.
1. Make sure that the BOOTP server is correctly
configured for this client.
2. Check the network connection. If the network
connection is good, retry the operation. If there is no
network connection, contact your network
administrator.
3. If there are no problems with the BOOTP server or the
network connection, replace the system-board
assembly. Contact a service support representative for
more information.
20A80100 A SAN device was found in the boot
list; however, the ibm,fw-fcpdisk
alias name has not been defined in
the /alias node.
Type the setup-fc-disk command at the open firmware
prompt and press Enter; then, restart the blade server.
20A80102 The ibm,fw-fcpdisk alias is not a
SAN device.
Run the setup-fc-disk utility.
20A80104 The disk2 alias was found and
copied to the ibm,fw-fcpdisk alias.
This is an informational message. No action is required.
20A80110 The ibm,fw-fcpdisk alias was
modified.
This is an informational message. No action is required.
20D0000F The device failed the self-test; error
or location code information might not
be available.
v If a location code is specified, replace the device at that
location.
v
Perform the system checkout procedure. See “System
checkout” on page 48.
20D00010 The device failed the self-test; cannot
locate package.
1. If a location code is reported with the error, replace
the device at that location code.
2. Replace the system-board assembly. Contact a
service support representative for more information.
20D00011 The run-time extraction services
(RTAS) program attempt to allocate
memory failed.
Perform the system checkout procedure. See “System
checkout” on page 48.
66
BladeCenter JS20 Type 8842: Installation and User’s Guide