IBM BladeCenter JS20, Installation And User Manual

Page: 84 / 132

Table 1. Abbreviated list of firmware error codes (continued)
Error code Failing device or problem found Suggested action
25A80000 Initialization failed; the device failed
the test.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80100 The NVRAM data validation check
failed.
1. Turn off the blade server; then, turn it on.
2. Retry the operation before replacing any system
component.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80201 Unable to expand target partition
while saving configuration variable.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80202 Unable to expand target partition
while writing BladeCenter
management-module event log entry.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
25A80203 Unable to expand target partition
while writing VPD data.
If the problem remains, replace the battery in the blade
server. For additional information, see the Hardware
Maintenance and Troubleshooting Guide.
Note: After you replace the battery, you must reset the
system date and time through the operating system that
you installed.
If the problem still remains, replace the system-board
assembly. Contact a service support representative for
assistance.
72
BladeCenter JS20 Type 8842: Installation and User’s Guide