IBM 8669 - Eserver xSeries 342, Hardware Maintenance Manual

Page: 73 / 156

3-Pack Ultra 160 Hot-Swap Expansion Kit
You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in the server to
provide three additional hot-swap hard disk drives.
Filler panels
Hot-swap expansion option
To install a xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in “Before you begin” on page 40, “Safety information”
on page 109, and “Handling static-sensitive devices” on page 41.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the cover and bezel. (See “Removing the cover
and bezel” on page 42.)
3. Release the side latches to remove the filler panels from the bays below the
CD-ROM drive.
4. Refer to the documentation provided with the option to assemble the hot-swap
expansion option.
5. Slide the hot-swap expansion option into the bays and attach it to the server
with the screws provided in the kit.
6. Refer to the documentation provided with the option to complete the installation
of the option. (See “System board internal cable connectors” on page 35 for
locations of the cable connectors on the system board.)
7. If you have other options to install or remove, do so now; otherwise, go to
“Installing the server cover and bezel” on page 64.
Hot-swap fan assembly replacement
The server comes with three hot-swap fan assemblies. You do not need to turn off
the power to the server to replace a hot-swap fan assembly.
Installing options
63