IBM 8265 Nways ATM Switch, Installation Manual

Page: 43 / 102

Installing the Control Point and Switch Module
Before You Begin
Before installing a Control Point and Switch module:
Ÿ
Make sure that you also have the PCMCIA card containing the Control Point and Switch microcode.
There are two versions, a basic version containing IISP and UNI protocols, and an enhanced version
with additional PNNI protocol. One of these MUST be installed on the module before the module is
installed in the 8265.
Ÿ
If you are installing the memory upgrade for the standard Control Point and Switch module, make sure
that it is to hand.
The memory module must be installed on the Control Point and Switch module before its insertion in
the 8265.
Ÿ
(CPSW2 module only) — Check that the Power Control jumper setting is in the correct position. To
use the integrated power control functions, the FORCE RCTL jumper must be in the OFF (down)
position. If you are using Controller modules for power management, the jumper must be in the ON
(up) position.
Important!: If you are installing two CPSW2 modules, the jumper setting must be the same on both
modules.
Attention: You must not install an 8260 CPSW module into the 8265.
Figure 15 illustrates the PCMCIA card slot, memory bank location, and the location of the Power Control
(FORCE RCTL) jumper (CPSW2 modules only).
FORCE RCTL
Jumper
PCMCIA Card
DRAM Memory
Banks
Figure 15. 8265 Control Point and Switch Module
Chapter 5. Installing Modules
29