IBM 8265 Nways ATM Switch, Installation Manual

Page: 34 / 102

Installing an AC Power Supply
You can install power supplies in any of the power supply slots. A factory label located directly below the
power supply slots identifies the slot number associated with each power supply.
To install a power supply:
1. Remove the blank faceplate covering each slot in which you will install a power supply. Keep this
blank faceplate for later use.
2. Set the ON/OFF (I/O ) switch on the front of the power supply you are installing to the OFF (O)
position before inserting the power supply into the switch.
3. Slide the power supply into the selected power supply slot. Push the power supply unit into the switch
until the front panel of the power supply is flush with the front of the switch. The rear power supply
connectors should now be firmly seated into the 8265 power supply connectors.
O
I
Figure 8. Installing an AC Power Supply
4. Fasten the power supply to the 8265 by tightening the two screws on the power supply faceplate.
Ensure that both screws are securely fastened (finger-tight).
5. Plug the power cord into the power supply unit socket.
6. Set the power supply's ON/OFF (I/O) switch to the ON (I) position.
7. Repeat steps 1 through 6 for subsequent power supplies.
20
IBM 8265: Installation Guide