IBM 7015-R50, Installation And Service Manual

Page: 160 / 300

4-38
Service Guide
23.If you are removing the docking connector card and cable from the operator panel
docking bracket, remove the four mounting screws, and then remove the card and cable.
Docking
Connector
Card
Mounting
Screws
Docking
Bracket
Mounting
Screws
24.If you are removing the power cable assembly, perform the following substeps:
a. Using pliers, gently remove connectors P71, P72, and P73 from the rear of the media
module.
b. Remove the power cable from the plastic cable retainers, and then guide the power
cable out of the media module.
Bottom View of Media Module
Bottom of Media Module
Rear of
Media Module P72
(Fan 5)
P71
(Fan 7)
Cable Retainers
P7
P73
(Fan 6)
Note: If connector P71 on your cable is marked “Fan 4,” disregard. This connector
connects Fan 7, as shown in the figure above.
Replacement
Replace in the reverse order.