IBM 4693, Installation And Operation Manual, Page: 31 / 74

Created February 23, 1997
Installing a Lock Insert
The example shows how to install a lock insert in
a cash drawer. However, the procedure is the
same for installing a lock in any device. To check
that the slot at the bottom of the lock cylinder
aligns with the end of the lock insert:
1
Put the aligner into the empty lock cylinder.
2
Gently turn the aligner until you feel it go into
the slot at the bottom of the lock cylinder.
3
Turn the aligner so that the arrow points in
the proper direction for this device.
4
Remove the aligner.
Note: Some cash drawers may have a different
style lock. If the lock for your cash drawer is
different than the one described here, refer to the
instructions that came with the lock.
Be sure each lock and its keys have matching
numbers. To install the lock insert:
1
Remove the keys from the lock insert.
2
Push the brass installation/removal key fully
into the lock insert.
3
Hold the lock and brass key so that the key
points in the same direction as did the
aligner.
4
Push the lock insert and brass key fully into
the empty lock cylinder.
5
Hold the lock insert in place with your finger
and remove the brass key.
6
Test the lock to be sure it operates correctly
with the keys.
7
Return the brass installation/removal key, the
aligner, and blank lock installation handle to
your supervisor for safekeeping.
The lock insert is now installed.
Chapter 1. Installing Input/Output Devices
1-19