IBM 4693, Installation And Operation Manual, Page: 19 / 74

Created February 23, 1997
Installing the 9-Inch Video
Display
1
Hold the display and its base over the
system unit and route the two cables through
the opening at the rear of the base.
2
Ensure that two tabs at bottom rear of the
display base fit into slots in top of system
unit.
3
Place the display base over the three screw
holes in top of the system unit and tighten
the screws.
Note: The display should be mounted on
the left side when used with the Model 3R or
4R printer.
4
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Installing an Integrated Keyboard
Note: If your keyboard cable has a round plug
on one end, it may be easier to first connect the
round plug to the system unit and then route the
cable up through the opening of the system unit
that is inline with the keyboard socket. If the plug
is not round, follow these instructions.
1
Connect cable 5 to the keyboard.
2
Route the keyboard cable straight back and
through the nearest opening at the rear of
the system unit.
3
Place the keyboard so the slots in the front
of keyboard engage with tabs at the front
edge of system unit.
4
Be sure the side of the keyboard overlaps
the tabs on the side of the system unit.
5
Be sure the carder reader opening is aligned
with the slot in the system unit.
6
The keyboard is installed. Install any other
I/O devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Slot
Tab
Tabs
Slots
Card
Reader
Openings
Chapter 1. Installing Input/Output Devices
1-7