IBM 4693, Installation And Operation Manual, Page: 24 / 74

Created February 23, 1997
Install 40-Character Vacuum Fluorescent Display
II
Note: The yoke for a two-sided display is taller
than the yoke for a single-sided display. The
installation procedure is the same for both.
1
Plug display cable 4 into the display. The
end of the cable that has the round core
connects to the display.
2
Spread the arms of the yoke open slightly
and slide the display into the yoke.
3
Route the cable through opening in the
system unit at the base of display.
4
Attach the display post to the system unit,
using two plastic thumbscrews. The notch in
the base of the post faces the rear.
5
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Installing the Character Graphics
Display
1
Press the release buttons at bottom of
display to open the rear cover.
2
Display cable 4 has a black core near one
end. Plug that end into the correct socket
on the system unit. See Table 1-1 on
page 1-4 for plug locations.
3
Route the cable up through the opening in
the system unit and up through the display
post.
4
Plug the cable into the display.
5
Attach the display post to the system unit,
using two plastic thumbscrews. The notch in
the base of the post faces the rear.
6
Snap the rear cover closed.
7
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Display
Yoke
Release Buttons
Core
Notch
1-12
Installation and Operation for POS I/O Devices