IBM 4693, Installation And Operation Manual, Page: 23 / 74

Created February 23, 1997
Installing the 40-Character Liquid Crystal Display
1
Slide the display up into its holder until it
latches securely in place.
2
Route display cable 4 up through the post.
The end of the cable that has the round core
connects to the display.
3
Plug the cable into the display unit.
4
Hold the display holder against the post as
shown so the interlocking surfaces contact
each other.
5
Rotate the display holder toward you to its
final position. Make sure the display is
securely attached to the post.
6
Snap the round top cover onto the post.
7
Route the cable through opening in the
system unit at the base of display.
8
Attach the display post to the system unit,
using two plastic thumbscrews. The notch in
the base of the post faces the rear.
9
The display is installed. Install any other I/O
devices at this time, otherwise go to
“Installing the System Unit Rear Cover” on
page 1-21.
Notes:
a. Two displays can be stacked on a single
post. The displays can face toward the
front or the rear.
b. The optional ‘Y’ cable is required when
connecting two LCD displays to a 4694.
Chapter 1. Installing Input/Output Devices
1-11